A detailed step by step instructions in this article we are dealing with the subject matter, how to perform a vehicle lettering on a truck. As first of all need we of course motive, to be equipped with the truck. This should be preferably in vectorised form, that means it was with vector programs such as Adobe Illustrator, Corel Draw or created Freehand. A pixel graphic goes through with appropriate size and resolution as a possible motive for a truck label, however, consume such files typically also much space and slows down the functions of image editing programs, therefore this should be well considered. Now the appropriate subject is established, it can be printed out using a large-format digital printer on self-adhesive white foil. This film is three shifts, namely from the carrier material, the adhesive and the colored surface. The pressure of the slide is water – and weather-resistant and resistant to scratches, after this with a corresponding protective film is laminated.
Prints that go beyond the format of the printer, several vertical lines of the same motives, of course from the corresponding column, must be printed, be put together later in the installation. It is also possible for simple vector paths to convert these images and fonts and then cut to the appropriately colored foil using a plotter two-colour logos. The Plott in the connection, so that it can be applied to the vehicle, laminated be. Coating with foil tape made of paper or plastic, depending on whether you the vehicle of wet or dry adhesive is. If all preparations and prepares the prints or plots, it is time to label the vehicle. This is done in a protected clean environment such as a shed or a garage. There, the truck must be cleaned for the time being. It is best to clean the vehicle thoroughly with water and then, after it has been dried with an alcoholic solution to handle.